Good luck!In my experience with the Godmorgon, you have to make SURE that your plumbing goes as far back to flush against the wall as possible. ... Godmorgon/Tolken/Tornviken Vanity Countertop . Actually it was a great help because I did remember seeing a small piece of the counter left as sample and it did look like lava stone glazed on the top. Foil is wrapped vertically around the particleboard so there are no unprotected edges where water can penetrate.Cleaning the floor is a breeze since this solution is wall mounted and there are no legs that get in the way.The smooth-running drawers with pull-out stop, open all the way for a good overview without falling out.You can sense the calm every time you close the drawers thanks to the soft-closing mechanism. Sold separately.We're sorry, due to COVID-19 delivery times are running longer than usual. If you continue to use this site we will assume that you are happy with it. Thinking of combining two 31" Godmorgons and would love to use a custom counter with recessed or undermounted sinks. There’s plenty of space inside the shiny drawers for all your essentials.The IKEA website uses cookies, which make the site simpler to use. Please note that a silicone kit and a jigsaw are needed to attach the sink to the countertop. My advice would be to do the backsplash, countertops - and the floors - or nothing at all. In my experience selling lots of countertops (!) Sold separately.The sink is resistant to most chemicals, except for strong acids and strong alkalis.This furniture must be secured to the wall with the enclosed wall anchoring device.If you are uncertain about the strength of your bathroom walls we recommend that you use legs.Use the included measuring template before attaching the sink to the countertop.Let the silicone underneath the countertop harden for 2 hours before attaching the sink.Secure that the material in your bathroom walls can support the weight of the furniture. Hello, Does anyone have any advice/warnings about using a custom vanity with an off-center integrated sink on the Godmorgon 47 1/4″ base?I want (NEED) some counter space on one side, but have concerns about the drawers and sink. Best of luck!From my initial email they said "our stone tops are slabs that are pre-sealed and our vanities are made overseas in China". If you are uncertain about the installation, contact a professional.Wet marks should always be dried off as soon as possible to stop moisture penetration.Wipe clean with a water dampened soft cloth and a mild non-abrasive dish detergent or soap, if necessary.Wipe clean with a water dampened soft cloth and a mild non-abrasive dish detergent or soap, if necessary.Wipe clean with a water dampened soft cloth and a mild non-abrasive dish detergent or soap, if necessary.Do not use scouring powder, steel wool, hard or sharp tools which can scratch the surface of the sink.Water is precious and should not be wasted. If this will work, the cabinets would run $300 vs. $1500-2200 for custom. Then I would like a custom 72" countertop mounted on top of that, with a rectangular undermount sink in the center. ... Vanity, countertop and 17 3/4" sink 40 1/8x19 1/4x28 3/8 "$ 549. The high gloss finish makes your bathroom feel sparkling fresh so you … The ACE 1-1/2in cast elbow part number is 44489. Hi potatomasher. IKEA Vanity in Maple Veneer. I realize this will make the Godmorgon drawer directly under the sink unusable. So far everyone says its a bad idea because I wont be able to do the plumbing and if I manage to do it it will take too much space and top drawer will be useless.I was lucky enough to have brand new plumbing when locating the Godmorgon 47 1/4″ base in gloss white.