We attempted to use flex tape to repair with no luck. Just sit in the middle of the area and rotate the 2×4 around you, making sure the level reads level all the way around.If you don’t want to do this step yourself, you could always hire a local pro from The sand does make the bottom of the pool a bit softer when you’re swimming, but a nice padded pool floor liner would do the same.
Well, the hardest part in setting up this pool was the leveling. Your water level, maybe it is too high? This article covered many steps that I would have overlooked.wikiHow is where trusted research and expert knowledge come together. Is it safe to leave?Is there anyway to level without having to take it down?I did a 4 inch support wall and filled with sand to try and levelThat’s a good lesson for us all then, even with a 4″ support wall, the weight of the water will push the sand out from under the pool.
"We lost the instructions for setting up our pool. I did my best to level the ground around it. If there has been a storm, you might need to pull up large debris up from the bottom of the pool. The most common inflatable pool set up is the yard on grass for smaller inflatable pools, and on a leveled sand filled surface or concrete pad for larger inflatable pools. Adjust this schedule as necessary to accommodate pool use, excessive heat and heavy rains.Water assesment: Most swimming pool supply stores will do testing for free. Thanks so much!Mickel, I don’t believe that would be a good idea to use more than 1/2″ of pea gravel.
If you already have an area of the yard that is fenced off, that might be the perfect place to set up your new inflatable pool. We intend to leave it up all year.Hello, you could, but it would be best to do it like the manual describes, removing the turf/sod, so that the bottom are is solid and smooth and so that you can check level. Once you have a full pool, make sure to keep it clean by installing a filter and adding chlorine tablets. Please refer to the written instructions/DVD included with your pool package.The pool can only be left up year-round if the weather never dips below freezing where you live (32 degrees Fahrenheit or 0 degrees Celsius). We have a product that is a geotextile, very tough, stops weeds and even nutgrass. Proper Deck Board Spacing Even better than this would be to pour a solid, reinforced concrete pad on the pea gravel area, 13’x25′, especially if you plan to keep the pool for many years. How can I fix this?Can I put an intex rectangle pool over grass? Notice how he tries to find the flattest area to place the pool.The inflatable pool will not only exceed a typical decks weight limit, but the water splashing from the pool will rot the wood and damage the deck over time. They will check the pH, total chlorine and free chlorine levels. The pool is just about full but the upper ring is more oval than round. H Round Inflatable Above Ground Pool Set with Filter and Natural Chemistry (6-Pack) Model# 26175EH + 6 x 29000E + NC-05131 $ 791 31 perhaps if stone dust, aka crush-n-run was used, tamped and watered in place? Backyard Sidekick also participates in affiliate programs with Clickbank, CJ, ShareASale, and other sites. Please help us continue to provide you with our trusted how-to guides and videos for free by whitelisting wikiHow on your ad blocker. Without it, your pool will not remain clean and the water will be stagnant. Does the pool need to be totally full in order for the PVC ring to stay inflated? When the water spills occasionally it goes towards the left more . For yards that have a good slope to them, this may require over digging on the high side so there is a few feet between the new ‘wall’ that is created and the pool, and possibly constructing some sort of retaining wall out of 6×6 lumber or the stack blocks available at HD/Lowes. If the water in your inflatable pool does not warm up enough to make swimming enjoyable, consider purchasing and installing a solar heater. What goes in the second outlet hole on an Intex Easy Set Pool? ?Hey Carlos, the best way to level is to lower the high part to meet the low part, so that there is no fill dirt at all. Run pool pump for 1/2 hour to see how its doing, removing any debris missed before.